Build Molecules Logo
Build Molecules Build • Visualize • Learn

Hydrogen Sulfide Molecule (H₂S)

Hydrogen sulfide (H₂S) has a sulfur atom joined to two hydrogens by single bonds: it is water's "cousin".

You build it just like water, swapping the oxygen for sulfur.

H₂S
Molar mass
34.08 g/mol
Geometry
Bent
Bond angle
≈92°
Bonds
2 single
State (25 °C)
Gas
Melting point
−82.3 °C
Boiling point
−60.3 °C

Build the hydrogen sulfide molecule

The molecule is already built: move it, take it apart and put it back together. It is the same kind of board you will use in the app.

Atoms
H
S
Single
Drag atoms and bonds from the palette to build the molecule

How to use the board

  • Move the atoms. Drag any atom to move it: its bonds follow it.
  • Add pieces. Drag an atom or a bond from the palette onto the board.
  • Connect. Drop each end of a bond close to an atom and it snaps into place. Bonded atoms are marked with a ring.
  • Delete or start over. Drag a piece to the trash to delete it. "Restore" brings the molecule back and "Clear" empties the board. Use the magnifier or pinch to zoom.

Challenge: press "Clear" and build the hydrogen sulfide molecule again from scratch following the steps below.

How to create the hydrogen sulfide molecule in Build Molecules

In the app you build it just like on the board above, and you can also analyze the molecule to check it is correct.

  1. Open the Board

    In the Build Molecules app, go to "My Laboratory" and tap "Board". This is where molecules are built.

  2. Add the atoms

    Drag 2 hydrogen atoms (H) and 1 sulfur atom (S) from the "Atoms" palette. If one is missing, add it with "Edit Palette".

  3. Put them in place

    Place the sulfur with the two hydrogens on either side, slightly below, as in water. Join them with "Single" bonds.

  4. Join the atoms with bonds

    Drag 2 "Single" bonds from the palette. When you drop their ends close to the atoms they snap into place.

  5. Tap "Analyze"

    The app checks that every atom has the bonds it needs and recognises the molecule: hydrogen sulfide (H₂S). You can also load it ready-made from the "Library".

What you need to know about the hydrogen sulfide molecule

Bonds and Lewis structure

Sulfur has 6 valence electrons, like oxygen: it forms 2 S–H single bonds and keeps 2 lone pairs.

Geometry

It is bent, like water, but with a narrower angle of about 92°.

Properties

It is a colourless, toxic gas with the typical rotten-egg smell. It melts at −82.3 °C and boils at −60.3 °C: unlike water it is a gas, because it hardly forms hydrogen bonds.

Frequently asked questions

Why is H₂S a gas and water a liquid?

Because sulfur is less electronegative than oxygen and H₂S hardly forms hydrogen bonds: its molecules attract each other much less.

What does hydrogen sulfide smell like?

Rotten eggs. You can smell it even in tiny amounts, but at high concentrations it is very toxic.

Can I build the hydrogen sulfide molecule in Build Molecules?

Yes. Download Build Molecules from Google Play: build the hydrogen sulfide molecule on the Board, tap "Analyze" to check it and look at its Lewis structure.